Description
75 Litre Underslung Waste Water Tank FULL KIT for VW Crafter Man TGE 2017 onwards– Fits FWD MWB & LWB
Hatch Nut-in fittings
Medium and Long Wheelbase Models Only
Does not fit models with twin sliding doors
Waste Tank – Nut-in Fittings Supplied – Galvanised Brackets and fixings
KIT CONTAINS:-
- 1 x CAK- 238 Waste Water Tank 75 Litre with 3 breathers
- 1 x set of 3 custom made galvanised steel brackets
- 3 x 5” hookbolts with locking nuts
- 3 x 6” hookbolts with locking nuts
- 1 x drain tap with short hose and 2 x hose clips
- 1 x 25mm straight nut-in fitting
- 2 x 20mm elbow nut-in fittings
- 1 x 4” hatch (must be fitted to top of tank)
This waste tank is designed to fit along the driver’s side sill behind the driver’s door. Capacity of 75 litres.
Fixing kit supplied with 3 x galvanised brackets, 3 x 5 inch hookbolts and 3 x 6 inch hookbolts all with locking nuts.
The sill side of the brackets require the 6 inch hookbolts and the chassis side of the brackets require the 5 inch hookbolts.
All sill side 6” hookbolts hook into pre-existing sill bungs. Remove bung, hook in, then replace bung with small notch cut to allow for hookbolt.
All chassis side 5” hookbolts hook into pre existing holes in the base of the chassis.
Three nut-in fittings included. 1 x 25mm straight for the drain and 2 x 20mm elbows for the inlet. 4” hatch also supplied.
Recommend the use of smooth bore supaflex hose which is ultra flexible.
This tank can also be used for fresh, pressure fill (back fill) or gravity fill with pre-welded fittings. See separate listings.
OPTIONALS:-
– 1x Waste Water Level Gauge with Read out Panel (MTT/R)
– Defrost element (DFE-02)
20mm supaflex grey hose to fit inlet (H3SG)
Reviews
There are no reviews yet.